このページは役立ちましたか?

切断検出

    When outside calls are not properly disconnected by trixbox Pro , it is possible that your telco is not providing "Disconnect Supervision" as part of your service.

    Are you experiencing any of the following?

    1. When a call comes into a queue and is abandoned (caller hangs up) the call stays in the queue until it is picked up, but there is no one on the line.
    2. When someone outside your office drops off of a conference call the line is not released.

    If you experience either of the above and you are using a PSTN (or POTS) line, you may not have "Disconnect Supervision".

    Follow these instructions to determine if your POTS lines have Disconnect Supervision:

    1. Call into trixbox Pro from an external phone. Your cell phone is fine
    2. Dial an extension
    3. Pick up the extension by pressing the speakerphone button
    4. Hang up the *cell phone*
    5. Did your extension auto-hang up or play a tone after hanging up the cell phone?
     

     

    If YES to 5

    • You have Disconnect Supervision active on your lines
     

     

    If NO to 5

    • This means that you *do not* have Disconnect Supervision. You need to request it from your telco.

    If your telco cannot provide Disconnect Supervision they may be able to provide a busy signal once a call has ended. If they can, Fonality Support can configure your trixbox Pro for “Busy Detection”. This feature does not respond as quickly as Disconnect Supervision and you may hear part of the busy signal.

    If your telco cannot provide either service on your current line, you should request to be moved to a line that will allow Disconnect Supervision.

    This page has no content. Enrich Fonality Knowledge Base by contributing.

    このページは役立ちましたか?
    タグ (タグ編集)
    • No tags

    ファイル 0

     
    あなたはコメントを投稿するには ログイン しなければなりません。
    Powered by MindTouch Core